Bridjit Curb Cut Ramps

BRIDJIT is an expandable innovative curb ramp system that bridges the gap between the street and a rolled curb driveway entry, reducing the impact to your car and occupants by 80%.

BRIDJIT Fits Any Width Driveway Entry

The BRIDJIT 3 piece curb ramp set is 12 feet wide overall. Additional 4 foot wide ramp sections can be added to expand the driveway coverage to any width. BRIDJIT’s modular design adjusts to fit around curved driveway entries.

Why Choose the BRIDJIT Ramp System?

Easy to Install
Bridjit has an easy 2 person, 15 minute installation, and requires no special tools. Hardware is provided with your purchase.
Saves You Money
Bridjit minimizes the damage done to steering components and alignment caused by bouncing over rolled curbs. This helps maintain gas mileage & reduces maintenance costs and tire wear. Payback for your investment in BRIDJIT is estimated to be as little as one year or less.
Versatility
BRIDJIT is also an excellent solution for golf carts, motorcycles, RVs, and boats.
Saves Your Car and Your Body
Bridjit reduces driver & passenger back pain experienced while bumping over rolled curbs and protects low profile tires and rims from damage. Low profile vehicles (i.e. Corvettes and collector cars) can now enter your driveway without scrapes and bumps.
Neighborhood Friendly
Ramps have a full length waterway to allow for storm drainage, sloped ends ease vehicles up and over the ramp when parallel parking. BRIDJIT is easily flipped out of the way for periodic cleaning. BRIDJIT is not impacted by street sweepers.

Eco-Friendly: Manufactured from ground up recycled rubber tires.

(A 3pc. 12 ft. set of ramps uses 12 passenger tires.)

BRIDJIT Dimensions

The initial set of Bridjit ramps includes:
1 left ramp, 1 center ramp, and 1 right ramp measuring 48″ wide (4ft) by 16″ deep (see below).

Weight: Each section weighs approximately 50 lbs
Width: 48″
Length: 16″
Material: Recycled Rubber

Each piece above measures 4 feet wide, which means you’ll have a total coverage area of 12′. Additional 4′ sections can be purchased to widen your ramp; the number of sections depends on the width and depth of your driveway.
As an added benefit, BRIDJIT is available in smaller 4 foot sections to allow for segmenting around a cul-de-sac or curve. The connection bolts allow the device to make the turn, leaving an acceptable wedge of space between sections as they fit in place.

BRIDJIT Materials and Hardware

INCLUDES

1 Left Ramp | 1 Center Ramp | 1 Right Ramp

Curb ramps are black, but will weather to a dark gray over time.
Each curb ramp section weighs approximately 50 lbs.
Includes .5″ x 7.5″ galvanized bolts pre-inserted into the center sections. These bolts are used to keep the three sections together.

Will the BRIDJIT Ramp System Fit My Curb?

Measure 20″ out from the top edge of curb into the street.
Measure from the lowest point of the gutter, perpendicular to the first measurement. This distance should be between 1.75″ TO 3″

*If step 2 does not measure 1.75″ TO 3″ then the ramp is not for you.